Polaris MV700 - Manual (Page 30)

27
CONTROLS
Electrical Switches
WARNING
Activating the override switch while the throttle is open can cause
loss of control, resulting in severe injury or death. Do not activate
the override switch while the throttle is open.
Mode/Reverse Override Switch (1) - This vehicle is equipped with a
reverse speed limiter system. To gain additional power while backing,
depress the override switch. The override switch also allows activation
of AWD in reverse, if the AWD switch is on. This switch is also used
to toggle through the different modes of the rider information center.
See page 38.
Engine Stop Switch (2) - The engine will not
start or run when the switch is in the OFF position.
Its purpose is to provide the operator with a
quick means of engine shutdown in case of an
emergency.
Ignition Switch Lever (3) - To start the engine, slide the stop switch
to the center RUN position and turn the ignition switch lever clockwise
past the ON position. Release the lever when the engine starts.
NOTE: Both the ignition switch and the emergency engine stop
switch will shut off all electrical power to the vehicle,
including lights. To stop the engine, slide the stop switch
either right or left to the OFF position.
Infrared Light Switch (4) - Use this switch to activate the infrared
lights (if equipped). When the infrared lights are turned on, all other
lights on the vehicle are turned off.
Front/Rear Winch Switch (5) - Use the switch on the pod to select
either the front or rear winch.
Winch Operation Switch (6) - After selecting either the front or rear
winch with the switch on the pod, use the handlebar switch to operate
the winch. Operation instructions can be found in the winch operation
guide provided by the winch manufacturer.
1 3
2
5
6
4
2