Polaris MV700 - Manual (Page 42)

39
FEATURES
Instrument Cluster
Rider Information Center
The rider information center is located in the instrument cluster. All
segments will light up for 2.5 seconds at start-up.
NOTE: If the instrument cluster fails to illuminate, a battery
over-voltage may have occurred and the instrument cluster
may have shut off to protect the cluster’s electrical system. If
this occurs, take the ATV to your Polaris dealer for proper
diagnosis.
1. Gear Indicator - This
indicator displays gear
shifter position:
H = High Range
L = Low Range
N = Neutral
R = Reverse
P = Park
2. AWD Indicator - This
indicator illuminates
when the AWD switch is
in the AWD position.
3. Engine Hour Display Indicator
4. Service Interval/Diagnostic Mode Indicator
5. Low Battery and Over Voltage - This warning usually indicates
that the ATV is being operated at an RPM too low to keep the
battery charged. A low battery warning may also occur under normal
operation if the machine is at idle and high electrical load (lights,
cooling fan, accessories) is applied. Drive at a higher RPM or
recharge the battery to clear the warning.
6. Odometer/Tachometer/Tripmeter/ Hour Meter
7. Fuel Gauge - The segments of the fuel gauge indicate the level of
fuel in the front tank only. Since use of the rear tank is
recommended for normal operation, the rear tank may already be
empty. Refuel immediately if the last segment of the fuel gauge
clears.
8. Check Engine Warning Indicator - The word HOT displays if
the engine overheats. Do not operate the ATV if this warning
appears. Serious engine damage could result
9. Mode Indicator
8
5 4 3
1
6
2
9
7