Hdd (hard disk drive) handling care – Panasonic DMR-E85H User Manual

Page 13

Advertising
background image

13

RQT7462

G

e

tt

in

g

st

ar

te

d

When you use the discs recorded either PAL or NTSC, or playback a
title recorded on HDD using PAL or NTSC, refer to this table.

(

Y: Possible, t: Impossible)

§1

If you select “NTSC” in “TV System” (

➡page 41), the picture may

be clearer.

§2

Select “NTSC” in “TV System” (

➡page 41).

§3

If your television is not equipped to handle PAL 525/60 signals
the picture will not be shown correctly.

≥When playing back a title recorded on the HDD, ensure that you

match the “TV System” setting to the title (

➡page 41).

The HDD is a high precision recording instrument and because of its
long recording capability and high speed operation it is a very
special device that is easily susceptible to damage.
As a basic rule, save important video content to a DVD disc as
backup.

The HDD is a device that is not built to withstand

vibration/shock or dust

Depending on the setup environment and handling of the HDD some
content may become damaged and play and recording may no
longer be possible. Especially during operation, do not subject the
unit to any vibration, shock, or remove the AC mains lead from the
household mains socket. In the event of a power failure the content
during recording or play may be damaged.

The HDD is a temporary storage device

The HDD is not an everlasting storage device for recorded content.
Use the HDD as a temporary storage place for viewing once, editing,
or for saving to a DVD disc.

Immediately save (backup) all content as soon

as you feel there may be problem with the HDD

If there is an irregularity within the HDD, strange sounds or problems
with picture (block noise etc.) may result. Using the HDD in this
condition may worsen the problem and in the worst case the HDD
may no longer become usable. As soon as you notice this type of
problem, save all content to the DVD disc.
Recorded content (Data) on a HDD that has become unusable is
unrecoverable.

HDD recording time remaining

This unit records using a VBR (Variable bit rate) data compression
system to vary recorded data segments to match video data
segments which may cause differences in the displayed amount of
time and space remaining for recording.
If the remaining amount time is insufficient, erase any unwanted
titles to create enough space before you start recording. (Erasing a
play list will not increase the amount of time.)

When “HDD SLP (SLEEP)” appears in the

display

The HDD has automatically gone into SLEEP mode in order to
extend the life of the HDD.
≥Press [HDD] to activate.
≥While in SLEEP mode play or recording may not begin right away

because the HDD takes time to be re-activated.

≥If there is no disc in the unit, the HDD will go into SLEEP mode

after there has been no operation for 30 minutes or longer. When
not using the unit, we recommend removing the disc.

Types of disc or title recorded on HDD
for the type of connected TV

TV type

Disc/Titles

recorded on HDD

Yes/No

Multi-system TV

PAL

Y

NTSC

Y

§1

NTSC TV

PAL

t

NTSC

Y

§2

PAL TV

PAL

Y

NTSC

Y

§3

(PAL60)

Accessory discs

DVD-RAM
9.4 GB, double-sided, type 4 cartridge:
4.7 GB, single-sided, type 2 cartridge:
4.7 GB, single-sided, non-cartridge:

LM-AD240LE
LM-AB120LE
LM-AF120LE

DVD-R
4.7 GB, single-sided, non-cartridge:

LM-RF120LE

HDD (Hard disk drive) handling care

Setup precautions

Do not place in an enclosed area so the rear cooling fan

and the cooling vents on the side are covered up.

Place the unit on a surface that is flat and not subject to

vibration or impact.

Do not place on anything that

generates heat like a video cassette
recorder etc.

≥Do not place in an area often subject to

temperature changes.

≥Place in an area where condensation does not occur.

Condensation is a phenomenon where moisture forms on a
cold surface when there is an extreme change in temperature.
Condensation may cause internal damage to the unit.

Conditions where condensation may occur
–When there is an extreme change in temperature (moving from

a very hot location to a very cold location, or vice versa, or when
subjected to an air conditioner or when cooled air directly
impacts the unit.) When the HDD (warms during operation) is
subjected to cold air, condensation may form on the inside of
the HDD and may cause damage to the HDD heads etc.

–When there is high humidity or a lot of steam in the room.
–During the rainy season.

≥In the above situation, without turning the unit on, let the unit

adjust to the room temperature and wait 2–3 hours until
condensation is gone.

Cigarette smoke etc. causes malfunction or

breakdown

The unit may breakdown if cigarette smoke or bug spray/vapor
etc. gets inside the unit.

While operating

≥Do not move the unit or subject to vibration or impact. (The

HDD may become damaged.)

≥Do not remove the AC mains lead from the household mains

socket, or flip the power breaker switch.

While the unit is on, the HDD is rotating at high speed. Sound or
movement due to rotation is normal.

When moving the unit

1 Turn the unit off. (Wait until “BYE” disappears from the

display.)

2 Remove the AC mains lead from the household mains socket.
3 Move only after the unit has come to a complete stop (approx.

2 minutes) in order to avoid subjecting to vibration and shock.
(Even after turning the unit off, the HDD continues operating
for a short time.)

Indemnity concerning recorded content

Panasonic does not accept any responsibility for damages
directly or indirectly due to any type of problems that result in loss
of recording or edited content (data), and does not guarantee any
content if recording or editing does not work properly. Likewise,
the above also applies in the case any type of repair is made to
the unit (including any other non-HDD related component).

This unit

VCR

7462L.book 13 ページ 2004年3月24日 水曜日 午前11時4分

Advertising