Panasonic PV DM2093 - Manual (Page 59)

59 59
Ad
vanced Operation
*Important:
If a remote control button does not work when pressed, press the TV/VCR , DVD
button on the remote and try the button again.
• Make settings according to amplifi er
connected to optical audio output as shown
in above table.
*1 When connecting an amplifi er (with an
optical digital input connector) which
does not contain the Dolby Digital or
dts decoder, be sure to select “
PCM .”
If “Bitstream” is selected, starting DVD
play may cause such a high level of noise
as to be harmful to your ears and damage
the speakers.
*2 When a dts decoder is connected, please
select “Bitstream” in “dts.” If “PCM” is
selected, there will be
stereo sound.
AUDIO OUTPUT
Select the digital output to be output from the optical
digital audio output connector of the unit.
Do steps 1 and 2 on page 58.
■ “LPCM (DVD)” selections
OFF: Linear PCM of less than 48 kHz/16 bit
is output. When playing DVDs recorded
in linear PCM of over 48 kHz/20 bit, no
digital audio is output. (Factory preset)
PCM: When playing DVDs recorded in
linear PCM of 48 kHz/20 bit/24 bit or
more, digital audio converted to 44.1
kHz/16 bit or 48 kHz/16 bit is output.
(Digital output of PCM audio is restricted
to48 kHz/16 bit or below for copyright
protection.)
■ “Dolby Digital” selections
Bitstream: Dolby Digital bitstream (1ch-5.1ch) is
output. (Factory preset)
PCM: When you have connected a amplifi er
that doesn’t have a built-in Dolby Digital
decoder.
■ “dts” selections
Bitstream: dts bitstream is output. (Factory preset)
PCM:
When you have connected a amplifi er
that doesn’t have a built-in dts decoder.
■ “DRC (Dynamic Range Compression)”
selections
OFF: Normal audio range is selected. (Factory
preset)
ON: For dynamic sound even at low volume,
this is useful for late-night listening.
[Dolby Digital DVDs only].
1) Press to
select an item.
2) Press SET
repeatedly for
output. (See
below.)
1) Press to
select “AUDIO
OUTPUT.”
2) Press SET to
display screen.
1
3
2
4
Press ACTION to redisplay DVD MAIN MENU
and go to step 2 to setup another item. Or,
press ACTION three times to exit.
AUD I O OUTPUT
SELECT :
SET : SET
END : ACT I ON
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
DVD MAIN MENU
SELECT :
SET : SET
END : ACT I ON
D I SC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 Pa n & S c a n
Type of
amplifi er
to be
connected Recommended setting
LPCM
(DVD) Dolby
Digital
dts
No amplifi er
is connected
AV amplifi er
without Dolby
Digital/dts
decoder
PCM PCM* 1 PCM* 1
AV amplifi er
including
Dolby Digital
decoder
PCM Bitstream PCM
AV amplifi er
including
Dolby
Digital/dts
decoder
PCM Bitstream Bitstream * 2
SELECT
SET
ACTION