Panasonic AW-SW350P - Manual (Page 12)

23 22
■ INSTALLING THE DEVICE DRIVER
This section describes how to install the device driver used with the USB image transfer
program for the AW-SW350. In the example of the procedure given below, Windows XP is
used as the operating system.
Insert the CD-ROM supplied with the AW-SW350 in the CD-ROM drive of the host
computer. (In this example, E: is the drive used.)
Set the AW-SW350's Power Switch to ON, check that the Power Indicator has lighted,
and connect one end of the A-B type USB cable to the USB port on the rear panel of
the AW-SW350 and the other end to the USB port on the host computer. (Fig.1)
When the host computer recognizes the AW-SW350, as shown in Fig.2, the Found
New Hardware Wizard automatically starts up.
3
2
1
When the screen for specifying the driver loading directory appears as shown in Fig.3,
specify the \DRIVER folder of the drive where the CD-ROM supplied with the
AW-SW350 was inserted, and load the driver. (In this example, E: is the drive used.)
When the device driver has been loaded, a screen similar to the one shown in Fig.4
appears. This completes the installation of the device driver.
5
4
Fig.1 Connections
BBOUT GLIN
/BBOUT PVW
OUT
TALLY & INCOM
PGM OUT 2
5 4
DC 12V IN
SET UP USB EXT TAKE
PGM
Y / C
OUT
1 3 4 2
GND
3 2 1
1 1
75 Ω AUTO
2 3 4 5
1 2 3 4 5
VIDEO
IN
OUT
Y / C IN
AW-SW350
Windows PC
USB cable
Rear
Fig.2 Found New Hardware Wizard start screen
Fig.3 Driver specification screen
Fig.4 Driver loading completion screen