Paxar Stacker Monarch 932TM - Manual (Page 5)

G E T T I N G S TA R T E D
1
The Monarch® 932

stacker works with a Monarch® 9860

printer. The stacker supports backfeed mode on the printer. There
is no power ON/OFF switch for the stacker. Once the stacker is
plugged into an outlet, it is on.
U n p a c k i n g t h e S t a c k e r
u Important: After unpacking the stacker, look through all
packaging material for parts. Keep all packaging material
for future shipping.
I n s t a l l i n g t h e S t a c k e r
Use these instructions when you first install the stacker or when
you need to move the stacker to a different location.
Before installing:
u Find a level work surface at least 52" x 22"
(1321 mm x 559 mm).
The 9860 printer comes with a knife attached.
u Turn off the printer before you install the stacker.
Getting Started 1-1