Paxar Stacker Monarch 932TM - Manual (Page 7)

S t e p 2 - L e v e l t h e S t a c k e r
1. Check the distance between the rollers and the knife. Make
sure the rollers are not touching the front of the knife or too
far from the knife. If incorrect, follow the steps below. If
correct, skip this step and move on to Step 3 - Connect the
Power Cord.
The ideal position for the stacker is with the
end of tray slightly down.
2. Loosen the locking nuts with a wrench.
3. Make sure the stacker’s feet are flat
on a level surface.
You can raise or lower the feet
by turning them.
4. Evenly adjust both feet.
If the stacker is
u touching the knife case, lower the feet.
u too far from the knife, raise the feet.
5. Tighten the locking nuts.
Rollers
Knife
Locking
Nuts
Getting Started 1-3