Tea5880ts, Philips semiconductors – Philips TEA5880TS User Manual

Page 12

Advertising
background image

9397 750 13022

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

Preliminary data sheet

Rev. 02 — 26 April 2004

12 of 27

Philips Semiconductors

TEA5880TS

Integrated FM stereo radio IC for host processor tuning

[1]

The frequency is decreased when increasing the content of this register.

[1]

The frequency is increased when increasing the content of this register.

[1]

This register does not have an address. To read the status register, latch its content into the PISO (using
L_STS bit in control register B) then read out the PISO.

[1]

This register does not have an address. To read the counter register, latch its content into the PISO (using
L_CNT bit in control register B) then read out the PISO.

Table 15:

OSC_IF - (address 6h) bit description

[1]

Bit

Symbol

Description

14 to 11 -

address bits

10 to 0

IFO[10:0] 11-bit digital-to-analog converter for adjusting the IF frequency

Table 16:

OSC_FM - (address 7h) bit description

[1]

Bit

Symbol

Description

14 to 11 -

address bits

10 to 0

FO[10:0]

11-bit digital-to-analog converter for adjusting the FM frequency in fine steps;
this register is used in combination with the CAP_FM register to set a FM
frequency

Table 17:

STATUS - bit description

[1]

Bit

Symbol

Description

15 to 9

FS[6:0]

field strength, indicated by the amount of bits set:

0 bits set = < 10 dB

µ

V

1 bit set = 10 dB

µ

V to 20 dB

µ

V

2 bits set = 20 dB

µ

V to 30 dB

µ

V

3 bits set = 30 dB

µ

V to 40 dB

µ

V

4 bits set = 40 dB

µ

V to 50 dB

µ

V

5 bits set = 50 dB

µ

V to 60 dB

µ

V

6 bits set = 60 dB

µ

V to 70 dB

µ

V

7 bits set = > 70 dB

µ

V

8

-

not applicable; always read as logic 1

7 to 5

R[2:0]

chip revision; the revision for TEA5880TS is 100b

4 to 3

-

not applicable; always read as logic 1

2

-

reserved for production test

1

-

not applicable; always read as logic 1

0

-

reserved for production test

Table 18:

COUNTER - bit description

[1]

Bit

Symbol

Description

15 to 0

CNT[15:0]

pulses counted during the period that the counter is enabled and the NR/W
line the 3 wire bus is low

Advertising