Paradyne 392xPLUS - Manual (Page 266)

Sample Configurations
G-17 3920-A2-GN31-30 November 1996
3920Plus
E, G Use TMp Tributary template default configuration options with the following
exceptions:
Port2 MSD Set to Enable.
RTS Action Set to Sim_Cntl_Car.
Auto Dial Back Set to Enable.
Auto Dial Standby Set to Adv 15min.
Dial Line Rate Set to 14400(V32).
3920Plus F Use TMp Tributary template default configuration options with the following
exceptions:.
RTS Action Set to Sim_Cntl_Car.
Auto Dial Back Set to Enable.
Auto Dial Standby Set to Adv 15min.
Dial Line Rate Set to 14400(V32).
Cables
Cable 1 Use a standard, customer-supplied, EIA-232-D/V.24 cable with a DB-25-P (plug)
connector at one end to attach to the modem. Attach this to the connector labeled
DTE1, 2, 3, or 4.
Cable 2 Use part number 125-0053-1431 (an 8-position, 8-wire modular cord that is
supplied with the modem). Attach this to the connector labeled LEASED.
Cable 3 Use part number 818-2759-0111 or an equivalent customer-supplied,
EIA-232-D/V.24 crossover cable with DB-25-P (plug) connectors on both ends to
attach to the modems. (See Appendix C for pin assignments.)
Cable 4 Use part number 125-0067-0031 (a 6-position, 4-wire modular cord that is
supplied with the modem). Attach this to the connector labeled DIAL.