Panasonic SC-PM9 - Manual (Page 16)

16
RQT7360
Listening operations
Cassette tapes
1
Press [OPEN
0] to insert a cassette with the tape
facing in.
When the button is pressed, the unit comes on
automatically. Make sure the cassette is fully inserted and
close the lid by hand.
2
Press [TAPE
3] to start playback.
One side is played, then playback stops automatically. To
play on the other side of the cassette, turn the cassette
over and press [TAPE
3].
3
Adjust the volume.
Cassette tape selection and care
Types of cassettes which can be played correctly
Use normal position tapes.
High position and metal position tapes can be played, but the
unit will not be able to do full justice to the characteristics of
these cassettes.
• Tapes exceeding 100 minutes are thin and can break or get
caught in the mechanism.
• Tape slack can get caught up in the mechanism and should
be wound up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts
if used incorrectly.
To find the beginning of a program
(TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from there.
Each press increases the number of tracks skipped, up to a
maximum of 9.
Press [4 4 4 4 4/REW/4] or [3 3 3 3 3/FF/¢] during play.
Notes
The TPS function searches for silent parts of about 4 seconds in length
which are normally found between tunes. As a result, it may not function
properly in the following cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes
3
2
/ / REW ,
/ / FF
STOP
1
Top of the unit
1
OPEN
B
Insert inside the
guides
Forward side
OPEN
2
TAPE
3
To
stop tape playback
start one touch play
fast-forward and
rewind
Action
Press [STOP 7].
Press [TAPE 3] when the system is
OFF with the cassette loaded.
Press [4 4 4 4 4/REW/4] or [3 3 3 3 3/FF/¢] in
the stop mode.
RQT7360-B_13-16_EN 30/12/03, 4:13 pm 16