Panasonic VW-BN1 - Manual (Page 14)

14
LSQT1268 (ENG)
Put this unit near the outlet to make it
easy for the interrupting device (plug) to
reach it.
∫ About the disc
≥ If there is dust, a scratch, or dirt on
disc or if it is warped, the following
phenomena may occur:
– Block noise in playback image
– Momentary stop of playback image
– Sound interrupted during playback, or
abnormal sound
– Disc cannot correctly be recognized
– Delay between video and audio
When the ACCESS lamp is illuminated
(while accessing a disc), do not
disconnect the AC adaptor or the USB
cable or subject this unit to vibration
and shock.
DVD-R/DVD-R DL
≥ For optimum recording on DVD-R or
DVD-R DL discs, this unit writes control
data to a DVD-R or DVD-R DL used for
recording when it is being inserted and
ejected. If the disc has no area for
control data to be written, recording may
not be possible. To prevent this, do not
insert a DVD-R or DVD-R DL which has
been recorded on more than 50 times.
≥ Do not insert a DVD-R or DVD-R DL
recorded on this unit that has not been
finalized into a recordable device, such
as a DVD recorder. The recorded data
may be damaged.
∫ About condensation
Using this unit when condensation has
occurred may cause it to malfunction. Make
every effort to ensure that condensation
does not form. If it does form, take the
actions described below.
Causes of condensation
Condensation takes place when the
ambient temperature or humidity is
changed as follows.
≥ When this unit is brought inside from the
cold to a warm room.
≥ When this unit is moved from an
air-conditioned car to outside.
≥ When a cold room has been warmed up
quickly.
≥ When cool wind from an air conditioner
is directly blown onto this unit.
≥ After summer afternoon showers of rain.
≥ When this unit is in a very humid place
where the air is thick with steam.
When this unit is taken to a location with
a significant temperature difference
such as from a cold place to a hot place.
Place the unit inside a plastic bag, remove
as much of the air from inside the bag as
possible, then seal the bag. Leave the unit
for about an hour in the room so the
temperature of the unit is close to the
ambient temperature of the room, then use
it.
What to do when condensation forms
Disconnect the AC adaptor and leave the
unit for about 1 hour. Check that the
condensation disappeared naturally when
the unit became close to the ambient
temperature and then use the unit.
LSQT1268_Eng.book 14 ページ ２００７年７月２３日 月曜日 午後３時４４分