Panasonic VW-BN1 - Manual (Page 15)

15
LSQT1268 (ENG)
¬ Troubleshooting
Problem Check points
This unit cannot be
turned on. ≥ Is the AC adaptor connected?
> Connect the AC adaptor and the AC cable correctly. (P9)
This unit cannot be
operated even when
powered up.
This unit does not
operate normally.
≥ Disconnect the AC adaptor and then about 1 minute later
connect it again. (Conducting the above operation when the
access lamp is on may destroy the data on the disc.) If normal
conditions are not restored, detach from the connected power
source and consult the dealer who you purchased this unit from.
The [<] button does not
work.
≥ The disc will not eject unless this unit is powered.
> Connect the AC adaptor.
≥ The [<] button may not work when copying from a
connected Camcorder to a disc is in progress.
> Wait until the copying is finished.
≥ In cases other than the above, detach from the connected
power source and consult the dealer who you purchased this
unit from.
The disc cannot be read.
Copying stops.
The playback motion
video/pictures breaks up
for a moment.
≥ Is the disc scratched or dirty?
> Wipe off the dirt on the disc. (P7) If the disc is scratched,
insert a new one.
≥ The internal temperature of this unit is high. Disconnect the AC
adaptor, wait a short while and then you will be able to use this
unit again.
≥ Discs recorded on other devices may not be correctly read or
played back on this device.
Cannot copy although
power is supplied to this
unit and the disc is
correctly inserted.
≥ Has the DVD-RW, DVD-R or DVD-R DL been finalized?
> After finalizing, the discs become play-only and cannot
record. If you un-finalize a DVD-RW, it can be used for
recording. (If you un-finalize a DVD-RW and then use it again
when copying from a compatible Panasonic
Camcorder , the
recorded scenes may be deleted.)
≥ Is the memory of the disc full?
> If there is no more available memory, delete unnecessary
scenes with the PC or use a new disc.
LSQT1268_Eng.book 15 ページ ２００７年７月２３日 月曜日 午後３時４４分