Panasonic WJ-ND200 - Manual (Page 34)

34
Supplies a signal from the ALARM connector or the ALARM/CONTROL connector on the rear panel of this
unit (Alarm signal output)
It is possible to output signals from the ALARM connector or the ALARM/CONTROL connector on the rear panel of
the unit and sound the buzzer when an event occurs. The alarm signal output duration can be configured on the
setup menu. (Refer to the setup instructions (PDF) for further information.)
Records the event log
The event type and the occurrence time and date will be recorded when an event occurs.
Transmits recorded images to an FTP server at an event occurrence
When an event occurs, recorded images will be continued transmitting to an FTP server automatically for the set
duration from the recording start time. To send the alarm mail at an event occurrence, it is required to perform the
settings on the setup menu in advance. (Refer to the setup instructions (PDF) for further information.)
Notifies of an alarm occurrence according to the Panasonic alarm protocol settings
Select "ON" or "OFF" to determine whether or not to notify of an alarm occurrence (or error information) to a PC
according to the "Panasonic Alarm Protocol" of the setup menu ("Comm" – "Panasonic Alarm Protocol").
To receive a notification (or error information) and display the contents of the notification, the optional software (WV-
AS65, ver. 3.0 or later) is necessary.