Pride Mobility Jet2HD - Manual (Page 18)

18 www.pridemobility.com J et 2 HD
I V . A S S E M B L Y
To install the seat:
1. Position the seat on the seat post. See figure 10.
2. Push the seat down until the latch engages. See figure 11.
3. Plug the controller and charger inhibit connector into the
electronics tray. See figure 6.
Controller Installation
Your power chair may have been shipped without the con-
troller installed in the armrest.
To install the controller:
1. Flip up the armrest and loosen the setscrew. See figure 14.
2. Slide the controller mounting bracket into the armrest to
the desired position.
3. Tighten the setscrew to secure the controller.
WARNING! Do not place the controller cable
so that it can be pinched in the seat frame or
the power base frame.
Seat Installation
WARNING! Do not pick up the seat frame by
the armrests. They are free to pivot, and
you may lose control of the seat if they do
so, resulting in personal injury or damage to
the chair.
Figure 10. Seat Post
Figure 11. Seat Installation
SEAT
TOWER