Pride Mobility Jet2HD - Manual (Page 21)

J et 2 HD www.pridemobility.com 21
V . C O M F O R T A D J U S T M E N T S
Figure 15. Foot Platform Height Adjustment
NUTS AND BOLTS
Figure 16. Foot Platform Angle Adjustment
SETSCREW
Figure 17. Swing-away Footrests
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot platform bracket.
See figure 15.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the nuts and bolts into the foot platform bracket
and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
To adjust the foot platform angle:
1. Loosen the jam nut. See figure 16.
2. Turn the setscrew clockwise to lower the front of the foot
platform.
3. Turn the setscrew counterclockwise to raise the front of
the foot platform.
4. Tighten the jam nut.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off of your power
chair.
To move the SFRs:
1. Push in the release lever. See figure 17.
2. Move the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the side of
each footrest. See figure 17.
2. Slide the footrest in or out to the desired length.
3. Reinstall the two adjustment screws on each footrest.
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of adjust-
ment for the leg angle and a footrest adjustment range of
12–19 in.
To rotate the ELRs:
1. Push in release lever A. See figure 18.
2. Rotate the ELRs.
JAM NUT
FOOTREST
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER