Pride Mobility Jet2HD - Manual (Page 22)

22 www.pridemobility.com J et 2 HD
V . C O M F O R T A D J U S T M E N T S
Figure 19. Anti-tip Adjustment
ANTI-TIP ADJUSTMENT
NUT
To adjust the ELR angle:
1. Push down release lever B. See figure 18.
2. Move the leg rest to the desired angle.
To adjust the ELR length:
1. Remove the two adjustment screws from the side of each
leg rest extension. See figure 18.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws on each leg rest
extension.
Anti-Tip Wheel Adjustment
The anti-tip wheels are designed to give your power chair in-
creased stability on rough surfaces. The anti-tip wheels are
preset at the factory for smooth surfaces or indoor use only. If
you plan on using your power chair on rough surfaces, it may
be necessary to adjust the anti-tip wheels to better suit your
needs. The anti-tip wheels may need adjustment if the follow-
ing occurs:
! When coming to a stop, your power chair tips forward
excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized Pride Pro-
vider before attempting to change the anti-tip
wheel height! Changing the anti-tip wheel
height affects handling under deceleration!
WARNING! The higher you raise the anti-
tip wheels, the more you increase your
power chair’s tendency to tilt forward while
decelerating. You can compensate for this
by having your authorized Pride Provider
make a small adjustment to the pre-
programmed deceleration setting in the
controller or by moving the seat assembly
farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip
wheels.
To adjust the anti-tip wheels:
1. Remove the seat and body shroud. See VI. “Disassembly.”
2. Adjust the anti-tip adjustment nut so that the anti-tip
wheel is 0.5-1 inch off of the ground. Turn the nut
clockwise to raise the anti-tip wheel and counterclock-
wise to lower the anti-tip wheel. See figure 19.
Figure 18. Elevating Leg Rests
ADJUSTMENT
SCREWS
RELEASE LEVER B
RELEASE LEVER A
LEG REST
EXTENSION