Philips HK-0947-NP2500-FR - Manual (Page 18)

16
The onscreen display guides you
through the process of connecting
NP2500 to your home network and
the Internet. This section describes
the typical wired setup with static
IP address. You can also follow the
onscreen prompts for advanced
configurations that are not described
in this manual.
1
Connect an Ethernet cable (sold
separately) to the ETHERNET jack of
NP2500 and the Ethernet jack of the
wired router.
2
Ensure that the wired router is turned on
and has broadband Internet access.
3
Follow the steps in chapter First-time
connection to home network until
NP2500 shows the prompt for the
network setup.
4
Select [Wired (Ethernet)] to start the
network setup process.
NP2500 tries to acquire an automatic »
IP address.
Press
» BACK to enter your IP
address manually.
5
Enter your static IP address and confirm.
NP2500 shows the confirmation for »
the connection to the network.
NP2500 shows the prompt for the
»
connection to the Internet.
6
Select [Yes] to connect to the Internet.
NP2500 shows the confirmation for »
the connection to the Internet.
EN