Patton electronic 2616RC - Manual (Page 23)

Cable installation 23
Model 2616RC T-DAC User Manual 2 • Hardware installation
Figure 6. Ethernet RJ-45 pin and signal definitions for T-DAC
Connecting the 10/100Base-T Ethernet port to an Ethernet-capable
workstation or PC
The 10/100Base-T Ethernet port can connect to a single Ethernet-capable workstation or PC by means of a
cross over cable. Refer to
figure 7 to assemble a cross-connect cable that will connect between the NIC Ether-
net port in the workstation and the T-DAC 10/100Base-T Ethernet port.
Figure 7. Cross-over RJ-45-to-RJ-45 Ethernet cable diagram
Connecting the EIA-561 RS-232 configuration port (DCE configured)
Install the supplied RJ-45-to-RJ-45 cable with the DB9-RJ45 adapter between the T-DAC RS-232 port (see
figure 5 on page 22) and an open serial port on your computer. If you need to assemble your own cable, refer
to the pinout diagram in figure 8 .
Figure 8. DB-9-to-RJ-45 cable diagram