Panasonic PT-AE4000U - Manual (Page 16)

16 - E NGLISH
Basic
Operation
Switching the projector on/off
Basic Operation
Power cord
Connecting
J
Make sure the shape of the power plug and the 1.
AC IN terminal on the back of the projector match,
then push the plug all the way in.
Align the side of the 2. power cord secure lock with
the side guide rail of the AC IN terminal of the
projector and slide it in.
Rail guide
Place the latch to the latch catcher and press until 3.
it clicks.
Latch
Connect the power cord to a wall outlet. 4.
Disconnecting J
Unplug the power cord from the wall outlet. 1.
Depress the latch and slide the cover off. 2.
Slide the power cord secure lock up along the side 3.
guide rail.
Hold the plug and unplug it from the 4. AC IN
terminal on the back of the projector.
NOTE:
Do not use other than the provided power cord. •
Ensure all the input devices are connected and turned off before connecting the power cord. •
Do not force the connector as this may damage the projector and/or the power cord. •
Dirt or dust build-up around plugs may cause fire or electrical hazards. •
Switch off the power to the projector when not in use. •
Power indicator
Power indicator informs you of the status of the power.
When the TEMP indicator is flashing, the power
indicator will turn red, and you cannot switch on the
power.
Power indicator
Indicator status Status
No illumination or flashing MAIN POWER is switched off.
Red
Lit MAIN POWER is switched on and the projector is in standby mode.
Flashing
MAIN POWER is switched on (standby mode) and the POWER ON LINK is set to
YES.
The power consumption is not much different when it is lit. •
( See “VIERA Link Connection” of the functional instructions that is in the provided
CD-ROM.)
Green
Flashing The power button is switched on and the projector is getting ready to project.
Lit Projecting.
Orange
Lit The power button is switched off and the projector is cooling the lamp.
Flashing
The power button is switched on again when cooling the lamp and recovering to
projection mode. Recovery may take a while.
NOTE:
See “TEMP indicator” on page • 25.
While the projector is cooling the lamp, do not switch • MAIN POWER off or unplug the power cord.
The electric consumption in standby mode is 0.08 W. •