Philips MX5800SA/22S - Manual (Page 38)

38
English IMPORTANT!
– Make sure the FM and MW
antennas are connected.
– The TUNING button on the front
panel is used to toggle between
frequency tuning and preset tuning.
When in preset tuning mode,
pressing
S / T buttons on the
front panel will change the preset
number. Otherwise, pressing
S / T will change the radio
frequency.
Tuning to radio stations
1
Press TUNER on the remote (or adjust
SOURCE control on front panel) to
select “
FM TUNER” or “MW TUNER”.
2
Press and hold
S / T on the
remote until the frequency indication
starts to change, then release.
➜ The next radio station will tune
automatically.
➜ lights up for FM stereo reception.
3
To tune a weak station, press
S / T
briefly and repeatedly until an optimal
reception is found.
● If you use
S / T on the front panel
for frequency tuning, make sure the
system is in frequency tuning mode.
If not, press TUNING.
➜ " FREQ MODE" appears.
Presetting radio stations
You can store up to 40 preset radio
stations in the memory, starting from FM
and followed by MW
bands.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no stereo frequency is detected during
Plug and Play, "
CHECK ANTENNA"
appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
DVD VIDEO DIGITAL SURROUND SYSTEM
STOP PLAY• PAUSE SEATING
TREBLE
BASS
SOURCE VOLUME
PROG TUNING CLOCK•TIMER
SURROUND SEARCH
SC CHANGER
DVD DISC
SU R- R
RIG H T
CENTRE
LE FT
SUB
SU R-L
PLAY• PAUSE
AUTO INSTALL - PRESS PLAY
1
Connect the system to the power supply,
"
AUTO INSTALL - PRESS PLAY"
appears.
OR
In Eco Power standby/standby mode,
press and hold ÉÅ on the front panel
until "
AUTO INSTALL - PRESS
PLAY" appears.
2
Press ÉÅ on the front panel to start
installation.
➜ " INSTALL TUNER" appears.
➜ All previously stored radio stations will
be replaced.
➜ Once completed, the last tuned radio
station will play.
Tuner Operations