Philips MX5800SA/22S - Manual (Page 40)

40
English Setting the timer
The system can switch on to DISC or
TUNER mode automatically at a preset
time, serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure
that the clock is set correctly.
– The volume of the timer will
increase gradually to the last tuned
volume level. If the last tuned
volume level is too low, the set will
then increase to a predetermined
minimum audible level.
SEARCH
SOURCE
CLOCK•TIMER
CLOCK•TIMER
CLOCK•TIMER
2
3
5
4
6
SELECT CLOCK OR TIMER
TIMER
12:00AM
TUNER
10:38AM
DISC
12:00AM
DISC
1
Press STANDBY ON to switch on the
DVD system.
2
Press and hold CLOCK•TIMER until
"
SELECT CLOCK OR TIMER"
appears.
3
Press T (if necessary) to change the
display to "
TIMER", then press
CLOCK•TIMER again to confirm.
4
Adjust SOURCE (or press
DISC/MEDIA or TUNER on the
remote) to select the wake up source
(DISC or TUNER).
5
Press S / T to set the wake up
time (minutes and hours).
To increase the speed, hold down
S or T.
➜ The changes in minutes will roll over
to the hours.
6
Press CLOCK•TIMER again to store
the setting.
➜ Once the timer is set, it will always
switch on unless you deactivate it.
➜ icon will remain on the display panel.
It indicates the timer is activated.
● At the preset time, the selected
sound source will play for 30
minutes before it switches to Eco
Power standby mode (if no button is
being pressed within the time frame).
➜ DISC – the first track of the last
selected disc will be played. If the last
selected disc tray is empty, it will switch
to the next available disc. If all the disc
trays are not available, it will switch to
Tuner mode.
➜ TUNER – the last tuned radio station
will be played.
Activating /Deactivating the timer
1
Repeat steps
1
~
3
of “Setting the
timer”.
2
Press Ç to turn off the timer.
➜ icon will disappear from the display
panel and " TIMER OFF" appears.
OR
Press CLOCK•TIMER to turn on the
timer to the last setting.
➜ The timer information will display for a
few seconds, then the system resumes its
last active source or stays in standby
mode.
Helpful Hint:
– The system will exit timer setting mode if
no button is pressed within 90 seconds.
Timer Operations
buttons on
front panel DVD system’s
display panel