Paradyne 3160 - Manual (Page 91)

Operation
3-57 3160-A2-GB21-80 March 1999
Table 3-6. Valid Phone Number Characters
Valid
Characters
Meaning Restrictions
0 to 9 DTMF or pulse digits —
* # DTMF digits —
P Selects Pulse dialing Pulse or Tone must be specified,
otherwise Tone is the default. This
must be the first character in the
string, unless the first character is
B. Then, it must immediately
follow the B.
T Selects Tone (DTMF) dialing Tone or Pulse must be specified,
otherwise Tone is the default. This
must be the first character in the
string, unless the first character is
B. Then, it must immediately
follow the B.
W Wait for dial tone —
B Blind dialing (you need not wait
for a dial tone before entering the
dialing sequence) To be valid, this must be the first
character in the string.
, Creates a 2-second pause in the
dialing sequence —
<space> ( ) - Extra characters for readability.
The space is the default
character. —
<- End Of Number (EON) character,
terminates the dial string and
erases all characters to the right
after F3 (Save) is pressed —
Initiating a Call for Front Panel Pass-Through Operation
Front panel pass-through initiates a call through the integral modem to access a
far-end DSU/CSU’s front panel from your DSU/CSU’s front panel (or PC attached
to the COM port).
NOTE:
Pass is only available when the FP Pass configuration option has been
enabled (see Appendix C,
Configuration Options ), the active physical
interface is either the front panel or the PC, and the integral modem is not
already in use.