Philips AJ 3140 FAMILY - Manual (Page 6)

Controls Installation
6
AJ 3140/00 page 6
English
1 RADIO
to switch radio mode ON/OFF
2 ALARM 2 mode selector
BUZ(zer) - to activate buzzer for Alarm 2 setting
RAD(io) - to activate radio for Alarm 2 setting
OFF - to switch off Alarm 2
3 ALARM 1 mode selector
BUZ(zer) - to activate buzzer for Alarm 1 setting
RAD(io) - to activate radio for Alarm 1 setting
OFF - to switch off Alarm 1
4 Speaker
5 SLUMBER
to set/activate slumber time
6 7 fast up:
to adjust the hours and minutes for TIME and
ALARM TIME
7 4 slow down:
to adjust the hours and minutes for TIME and
ALARM TIME
8 ALARM 1
to adjust/review ALARM 1
9 ALARM 2
to adjust/review ALARM 2
0 TIME
to adjust clock time
! RESET
to stop the active alarm for 24 hours
@ SLUMBER OFF/REPEAT ALARM
to switch off the alarm for 7 minutes
# Dial scale
$ VOLUME
to adjust the sound level
% Display
^ BAND
to select FM-MW or LW waveband
& TUNING
to tune to radio stations
1. Check if the mains voltage as shown on the type
plate on the back of the set corresponds to your
local mains supply.
If it does not, consult your dealer or service
organisation.
2. Connect the mains plug into the wall socket.
– The mains supply is now switched on and the
numbers on the display will start to flash.
You will need to set the correct time.
3. To disconnect the set from the mains completely,
withdraw the mains plug from the wall socket.
– When a power failure occurs, the complete clock
radio will be switched off.
– When the mains supply returns, the numbers on the
display will start to flash and you will need to reset
the correct time on the clock.
– To retain the clock time and the set alarm time(s) in
the event of an power failure or disconnection, you
can insert a 9 volt battery (not included), type 6F22,
into the battery compartment:
should there be a power failure, the clock will
continue to function. However, the time will not be
illuminated on the clock display, as the use of the
battery is strictly to retain both the set clock and
alarm time(s) only, where actual operation of the
alarm and radio is excluded.
As soon as the power is switched on again,
the display will indicate the correct time.
1. Before inserting the battery, connect the mains
plug to the wall socket.
2. Place the battery into the battery compartment
on the underside of the clock radio.
– Replace the battery once a year, or as often as
necessary.
POWER FAILURE
MAINS CONNECTION CONTROLS