Panasonic CM0310DY0-CD - Manual (Page 58)

Feature/Code Selection
Setting the waiting time for
the power save mode
MBNM4NM0NM3N To set the length of time before the unit enters power save mode.
M1N “5min” (default): 5 minutes
M2N “15min”: 15 minutes
M3N “30min”: 30 minutes
M4N “1h”: 1 hour
Note:
R When in power save mode, the unit needs to preheat the fuser unit before
it can begin printing.
Holding the previous contrast
setting
MBNM4NM6NM2N M0N “DISABLED” (default): Deactivates this feature.
M1N “ENABLED”: The unit will hold the previous setting.
Note:
R The previous setting will be held individually for copying.
R The previous setting will be held individually for sending faxes (KX-MB2030
only).
Setting the default operation
mode
MBNM4NM6NM3N
(KX-MB2030 only) To select the default operation mode when the selected time of the mode timer
(feature #464) passes.
M1N “COPY” (default): Copy mode is selected as default.
M2N “FAX”: Fax mode is selected as default.
Note:
R You cannot select the scan mode using this feature.
Setting the default operation
mode timer
MBNM4NM6NM4N
(KX-MB2030 only) To set the timer before returning to the default operation mode (feature #463).
M0N “OFF”: Deactivates this feature.
M1N “30s”: 30 seconds
M2N “1min” (default): 1 minute
M3N “2min”: 2 minutes
M4N “5min”: 5 minutes
Setting toner save feature
MBNM4NM8NM2N M0N “OFF” (default): Deactivates this feature.
M1N “ON”: The toner cartridge will last longer.
Note:
R This feature may lower the print quality by reducing toner consumption.
R This setting is valid for copying, and when the unit automatically prints
reports/lists.
R This setting is invalid for printing received faxes (KX-MB2030 only).
58
9. Programmable Features