Panasonic SC-BTT750 - Manual (Page 21)

Getting s
tar
te
d
21
VQT2W18
STEP 6:
Reprogramming the
remote control
When other Panasonic products respond to this
remote control
Change “Remote Control Code” ( > 39) on the main unit and
the remote control (the two must match) if you place other
Panasonic products close together and it responds to this
remote control.
To change the code on the main unit.
1
While stopped, press [START].
2
Press [ 3, 4] to select “Other Functions”
and press [OK].
3
Press [ 3, 4] to select “Setup
” and press
[OK].
4
Press [ 3, 4] to select “Others” and press
[OK].
5
Press [ 3, 4] to select “Remote Control
Code” and press [OK].
6
Press [ 3, 4] to select the code (1 or 2) and
press [OK].
To change the code on the remote control.
1
While pressing [OK]
Press and hold the number button
(1 or 2), which has the same number you
selected in the step 6 for more than 5
seconds.
2
Press [OK].
Inserting or removing
media
≥ When inserting a media item, ensure that it is facing the right
way up.
≥ While the reading indicator is displayed, do not turn off the
unit or remove the media. Such action may result in loss of
the media's contents.
≥ When removing the SD card, press on the center of the card
and pull it straight out.
∫ To switch sources
Press [BD/SD] to select “BD/DVD” or “SD”.
≥ If media is inserted while the unit is stopped, the source
switches automatically depending on the inserted media.
SD CARD
SC-BTT750_350P_VQT2W18_eng.book 21 ページ ２０１０年６月２１日 月曜日 午後４時５１分