Panasonic SC-BTT750 - Manual (Page 29)

29
VQT2W18
TV
Radio
Playback
1
Press [RADIO] to select “FM”.
2
Press the number buttons to select the
channel.
To select a 1-digit number
e.g., 1: [1]
B [OK].
To select a 2-digit number
e.g., 12: [1]
B [2].
Alternatively, press [ W, X] or [2, 1].
∫ Display on the main unit
TUNED/STEREO: Displayed when receiving stereo
broadcasting
TUNED: Displayed when receiving monaural
broadcasting or monaural sound is
selected.
∫ FM frequency step
Main unit:
The factory setting is set to 0.2 MHz, it can be changed to
receive broadcasts allocated in 0.1 MHz. You may need to
change this setting if the tuner seems to skip over the correct
frequency for stations in your area.
1 Press [SELECTOR] to select “FM”.
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
To return to the original settings, repeat steps 1 and 2.
≥ After changing the setting, previously preset frequencies will be cleared.
Preset them again.
TV Enjoying TV with unit’s
speakers
Preparation
Turn on your TV and select the appropriate audio input mode
[AUX, ARC, D-IN] to suit the connections to this unit. (
> 22)
You can enhance stereo sources with surround sound effect.
1
Press [SURROUND] several times to select
the effect.
2
While “MANUAL” is displayed on the unit’s display
Press [ 2, 1] and select the desired effect.
For more detailed information on this operation, please refer to
the “Enjoying surround sound effects” section on page 23.
You can adjust the mode depending on the source or situation.
1
Press [SOUND] several times to select the
mode.
2
While the selected mode is displayed on the unit’s
display
Press [ 2, 1] and select the desired setting.
For more detailed information on this operation, please refer to
the “Changing the sound modes” section on page 23.
1
Press [EXT-IN] several times to select
“D-IN” (DIGITAL IN).
2
Press [AUDIO] several times to select the
type.
MAIN
SAP*
MAIN+SAP* (stereo audio)
* “SAP” = Secondary Audio Program
(Only works with Dolby Dual Mono)
≥ “MAIN” or “SAP” is not available if “On” is selected in
“Digital Audio Input”. ( > 37)
≥ Audio that is input through the DIGITAL AUDIO IN or AUX terminals are not
output from the HDMI AV OUT terminal.
Listening/confirming the preset
channels
∫ If noise is excessive
Press [AUDIO] to display “MONO”.
The sound becomes monaural.
Press the button again to cancel the mode. “AUTO
STEREO” will be displayed on the main unit. Depending on
the broadcast system, stereo or monaural will be selected.
“MONO” is also canceled when you change the frequency.
≥ This setting can be preset for each broadcasting station.
Surround sound effects
Surround modes to enjoy TV audio or stereo
sources from all speakers:
≥ DOLBY PRO LOGIC II MOVIE
≥ DOLBY PRO LOGIC II MUSIC
≥ SUPER SURROUND
Sound modes
Selecting the type of audio
from the DIGITAL AUDIO IN
terminal
SC-BTT750_350P_VQT2W18_eng.book 29 ページ ２０１０年６月２１日 月曜日 午後４時５１分