Philips AJ3130/05 - Manual (Page 10)

PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound
– Volume not adjusted
• Adjust VOLUME
MW broadcast cannot be received properly
– Weak radio signal
• Rotate the set for better reception and make sure that the
set is placed on a suitable (non-metallic) surface.
Continuous crackling and hiss noise during MW
reception
– Interference from other electrical equipment e.g. TVs,
computers, fluorescent lamps
• Move the clock radio away from electrical equipment
Intermittent crackling sound during FM reception
– Weak signal
• Adjust the pigtail aerial
The alarm does not function
– The alarm is not set
• Set the alarm time and the alarm switch to BUZZER or
RADIO
– Volume too low for radio
• Increase the volume
SLEEP does not function
– Radio still in ON position
• Switch RADIO to OFF
– Clock control in SET TIME or SET ALARM position
• Adjust clock control to CLOCK
10
TROUBLESHOOTING
English
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by
following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the
guarantee.