Panasonic PT-LM1U - Manual (Page 19)

E NGLISH -37
Adjustments
and
settings
36-E NGLISH
BRIGHT
This adjusts the darker areas (black
areas) in the picture.
Black areas are too light: I button
Dark areas are too solid: H button
COLOR
(S-VIDEO/VIDEO/YP B P R only)
The color is too deep: I button
The color is too pale: H button
TINT
(NTSC/NTSC 4.43/YP B P R only)
This adjusts the flesh tones in the picture.
The flesh tones are greenish: I button
The flesh tones are reddish: H button
SHARPNESS
To soften the picture details: I button
To sharpen the picture details: H button
COLOR TEMP.
This is used to adjust the white
areas of the picture if they appear
bluish or reddish.
White balance R/G/B
(W-BAL R/G/B)
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised.
To make the selected color lighter
: I button
To make the selected color stronger
: H button
This should normally be set to
“AUTO”. If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
T V - S Y S T E M A U T O
[
N T S C
[
N T S C 4 . 4 3
[
P A L
[
P A L - M
[
P A L - N
[
S E C A M
TV-SYSTEM
(S-VIDEO/VIDEO only)
AI
ON
The lamp is controlled according to
the input signals to project images
with the best quality.
OFF
“AI” is disabled.
C O L O R T E M P . S T A N D A R D
[
H I G H
[
L O W
STILL MODE
To reduce flickering of still images (vertical
flicker), set “STILL MODE” to “ON”.
SIGNAL MODE
(RGB/YP B P R only)
This displays the type of signal which is
currently being projected.
Refer to the table on page 58 for details on
each type of signal.
sRGB is an international color reproduction
standard (IEC61966-2-1) established by the
International Electrotechnical Commission
(IEC). If you would like the colors in sRGB-
compatible pictures to be reproduced more
faithfully, make the following settings.
# # Press the F F or G G button to select
“PICTURE MODE”, and then press the
I
I or H H button to select “NATURAL”.
$ $ Press the STD (standard) button on the
remote control unit.
% % Press the F F or G G button to select
“COLOR TEMP.”, and then press the I I
or H H button to select “STANDARD”.
S T I L L M O D E O F F
[
O N
A I O N
[
O F F
NOTE:
B sRGB is only enabled when RGB
signals are being input (when “LAMP
POWER” is set to “HIGH”).
NOTE:
B Do not set “STILL MODE” to “ON”
when playing back moving images.
NOTE:
B “AI” is disabled when “LAMP
POWER” is set to “LOW”.
(Refer to page 43.)
Projecting sRGB-compatible
pictures
NOTE:
B When set to “AUTO”, the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.