Panasonic TQBJ0303-1 - Manual (Page 36)

DISPLAY OPTION menu
36 -
E
NGLISH
Settings
DISPLAY OPTION menu
Navigating through the MENU ( Æ page 27),
select DISPLAY OPTION from the main menu
and then select the required item from the
sub-menu.
Set the selected item with◄►buttons. z
Remote control Control panel
ON-SCREEN DISPLAY
You can set the on-screen display.
Change setting Change setting
J
INPUT GUIDE
When you change the input method, the guidance
appears in the upper right corner of the screen. The
following display methods are available.
DETAILED
Display the input method by graphic.
The INPUT GUIDE will go out after
10 seconds without any operation.
OFF Turn off the guidance.
SIMPLE
Display the input method by text.
The INPUT GUIDE will go out after
5 seconds without any operation.
Remarks
If you select the computer terminals which have no z
signals while INPUT GUIDE is set to DETAILED,
the computer connection guidance will be displayed.
If you want to turn off the guidance, select SIMPLE
or OFF.
Q
Computer connection guidance
You can switch the signals which output from the
COMPUTER1/COMPUTER2 terminal by pressing
the following computer key commands.
Manufacturer
Image output
selection
command
Manufacturer
Image output
selection
command
Panasonic
NEC
+
DELL
EPSON
+
Acer
HP
SHARP
TOSHIBA
+
FUJITSU +
Apple
lenovo
SONY
+
Remarks
The key commands are depending on the z
manufacturers. Please refer to the instructions
which were provided with the computers for more
detailed information.
OSD DESIGN
J
You can change the background of the on-screen
menu (OSD).
TYPE1 Semi transparent black
TYPE2 Solid blue
TYPE3 Semi transparent dark blue
WARNING MESSAGE
J
You can choose to display or not to display the
warning massages.
ON Warning messages will be displayed
OFF No display
Note
When the z WARNING MESSAGE is set to OFF, use
the projector with utmost care due to the most of
warning messages will not be displayed.
STARTUP LOGO
You can set to display the Panasonic logo, your own
image or Pre-set letters, when starting up the projector.
Change setting Change setting
ON Display “ Panasonic” logo
TEXT Display the original text
USER
Display the image registered by
user
OFF No display
Remarks
If z TEXT is selected, the input letters are displayed
when starting up the projector. You can display
2 lines of original text which contain up to 40
characters each.
If z USER is selected, the image transferred by the
Logo Transfer Software is displayed when starting
up the projector. (You can download the Logo
Transfer Software from the Panasonic Projector
website (http://panasonic.net/avc/projector/
download/).)
STARTUP LOGO z will be displayed for 30 seconds.