Philips DVDR3588H/93 - Manual (Page 24)

E
n
g
li
sh
25
Auto Scan
Step 3: Installation and Setup
(continued)
TIPS: Press  to go access the options of an item in the menu.
Press SETUP to exit the menu.
GENERAL settings (underlined options are the factory default settings)
Record Mode
Auto Scan
Modify Channel
Timer Setting Menu
Sort Channels
SP
Search
Edit
OK
OK
Auto Chapter Marker 5min.
SETUP MENU - GENERAL
Start auto scan channel.
Select to start automatic TV channel programming.
A Use  keys to highlight { Auto Scan - Search } and
press OK .
 A warning message will appear.
B Select OK OK and press OK on the remote control
 Use  keys to highlight { Default TV System } and
press OK, Three modes PAL I , PAL D/K and PAL B/G will
appear, select correct mode , then press OK.
* Hint: The set does not support NTSC TV signal in.
 Use  keys to highlight { CONTINUE } and press OK on
the remote control.
 The automatic TV channel search will start. This process may
take several minutes. Once complete, the total number of
channels found will appear on the TV.
Select to modify your preset TV channels.
A Use  keys to highlight { Modify channel - Edit } and
press OK .
The modify channel options appears.
B Use  keys to select one of the options and press  .
{ Program Number } – Use CH+/ CH– or 0-9 keys to select by the
program
number for modifying.
The number of the current channel, this item can not be modified
{ Name } – Use  to select by the channel name for
modifying.
{ Standard } – Select this to set the system that produces the least
distortion of picture and sound. (See chapter “TV
System Guide” at the back of this manual for
information.)
{ Search type } –Use  to select scan mode, there are two mode:
Frequency and channel: To select Frequency mode,
the band item will not be available.
{ Frequency } – Select this to adjust the frequency of the channel.
– Use  keys to search the next frequency or use
the Numeric keypad 0-9 to change the frequency.
Press OK on the remote control to confirm the
setting.
{ Band } –The band of this channel, You can select standard or
cable.
{ Channel } – Use  to select and edit channel name.
{ Fine Tuning }– Select this to fine-tune the TV channel manually if the
reception is poor.
– Use  keys to fine-tune the frequency.
{ Delete File} – Select this to set the channel to be deleted.
C To confirm the changes, select OK OK
and press OK on the
remote control to exit to the previous screen.
Manual Program
Name
Program-Number
OK
PAL-B/G
CHANNEL
STANDARD Standard
Channel
Band
Search-Type
Fine-Tuning
Delete-File
P001
C-h-0-0-1
C---0-5
OK OK CANCEL
Ok
Manual-Program