Petsafe PDT00-12892 - Manual (Page 7)

www.petsafe.net 7
Operating Guide
Prepare the Handheld Transmitter
Charge the Handheld Transmitter
1. Lift the rubber dust cover protecting the Handheld
Transmitter Charging Jack.
2. Connect one of the charger connectors to the
Handheld Transmitter Charging Jack ( 1A).
3. Plug the charger into a standard wall outlet. The
Red LED will light up. When fully charged, the
LED will change to Green.
4. When charging is complete, be sure to replace
the rubber dust cover.
Note: Approximate battery life between charges is
40 to 60 hours, depending on frequency of use.
The Transmitter has two LED’s used to indicate
the selected dog. The Dog 1 Red LED is on the
left when holding the unit with the LED’s facing the
operator, and the Dog 2 Green LED is on the right.
1A
The transmitter is factory set in single dog mode. To verify, press and release the Dog
Select Button multiple times. (The Red LED will blink once for each press and release.)
Transmitter Indicators
Condition Red LED
Normal Operation OFF
Low Battery - press and release any
blue correction button
3 flashes every 5 seconds
Dog 1—any blue correction button ON length of any blue correction button
press. If a Static Stimulation button
is held up to 12 continuous seconds,
then a rapid flash will indicate a safety
time-out.
Charging ON
Condition Green LED
Normal Operation OFF
Dog 2—any blue correction button ON length of any blue correction button
press. If a Static Stimulation button
is held up to 12 continuous seconds,
then a rapid flash will indicate a safety
time-out.
Charging Complete ON
Step 1