Petsafe PDT00-12892 - Manual (Page 8)

8 Customer Care Center 1-800-732-2677
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber dust cover protecting the Receiver
Collar Charging Jack.
2. Connect one of the charger connectors to the
Receiver Collar Charging Jack ( 2A).
3. Plug the charger into a standard wall outlet. The
Red LED will light up. When fully charged, the LED
will change to Green.
4. When charging is complete, be sure to replace the
rubber dust cover.
To Turn the Receiver Collar On
1. Press and hold the On/Off Button ( 2B) until
the Green LED light comes on. (This takes
approximately one second.)
2. Release the On/Off Button.
In normal mode, the Green LED will flash once every 5
seconds, indicating the Receiver Collar is on and ready
to receive a radio signal from the Handheld Transmitter.
To Turn the Receiver Collar Off
1. When you press the On/Off Button, the Red LED
light will come on. Hold down the button until the
Red LED turns off (approximately 5 seconds).
2A
On/Off Button
2B
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar off when it is not in use.
Approximate battery life between charges is 15-20 hours, depending on frequency of use.
Receiver Indicators
Condition Red LED
Normal Operation - Low Battery 3 flashes every 5 seconds
Correction ON while delivering correction
Charging ON
Condition Green LED
Pairing Mode Flashes once every second
Normal Operation - Good Battery Flashes once every 5 seconds
Charging Complete ON
Step 2