Panasonic LC2H - Manual (Page 12)

LC2H
Part names
1. Front reset key
This key resets the count value. It does
not work when the lock switch is ON.
2. Mode key
Use to switch between each mode.
3. Setting key
Used to set digits of preset values or set
each mode.
4. Set key
Use to set preset values or to switch
between modes.
5. Lock switch
Disable the operation of the front panel
reset key and the mode key. With the lock
switch on,
is displayed for about
two seconds when the reset key or mode
switch is operated.
6. Count speed switch
Use this switch to switch the count speed
between 30 Hz and 5 kHz.
❇: Default setting when shipped.
Notes: 1. Make the switch setting before installing to panel.
2. Please turn the power off if you change the setting of the count speed switch when the power is on. The
setting will become valid when the power is turned back on.
5
Lock switch
(unit display 1)
6
Count speed switch
(unit display 2)
6
5
RESET MODE SET
COUNTER
LC2H
1 2 3 4
(Terminal block side)
(LCD side)
OFF ❇
ON
(Terminal block side)
(LCD side)
5kHz
30Hz ❇
Dimensions
• External dimensions
mm inch
General tolerance: ±1.0 ±.039
When installing the one-touch installation type model, make sure
that the installation spring does not pinch the rubber gasket.
To prevent the installation spring
from pinching the rubber gasket:
1. Set the rubber gasket on both
ends of the installation spring
(left and right).
2. Confirm that the installation
spring is not pinching the rubber
gasket, and then insert and fix the
installation spring in place from the
rear of the timer unit.
44.8
1.764
54.4
2.142
10.4
.409
44
1.732
5
.197
22
.866
7
.276
COUNTER
LC2H
RESET MODE SET
24
.945
48
1.890
• Panel cut out dimensions
The standard panel cut out is shown below.
Use the mounting bracket (ATH3803) and the rubber gasket (ATH3804).
(Only installation frame type)
• When installing repeatedly (sealed installation)
(Only installation frame type)
Notes: 1. Suitable installation panel thickness is 1 to 4.5 mm 0.39 to 0.177 inch .
2. Waterproofing will be lost when installing repeatedly (sealed installation).
45
1.772
+0.5
0
+.020
0
22.2
.874
+0.5
0
+.020
0
60 min.
2.362 min.
22.2
.874
+0.5
0
+.020
0
A=(48 ×n-2.5)
A=(1.890 ×n-.098)
A
+1.0
0
+.039
0
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: [email protected]