Philips HF3480 - Manual (Page 18)

Problem Solution
I do not hear
the alarm
sound when
the alarm goes
off.
Perhaps you set a sound level that is too low. To set a
higher sound level, see chapter ‘Using the appliance’,
section ‘Radio/volume’.
Perhaps you switched off the alarm function by
setting the control lever to the top position.
If you selected the radio as the alarm sound, the
radio may be defective. Switch on the radio after you
switch off the alarm to check if the radio works. If it
does not work, contact the Philips Consumer Care
Centre in your country.
The radio does
not work.
The radio may be defective. Contact the Philips
Consumer Care Centre in your country.
The radio
produces a
crackling sound.
Perhaps the broadcast signal is weak. Move the
middle dial up or down to adjust the frequency and/
or change the position of the antenna by moving it
around. Make sure you have unwound the antenna
completely.
The alarm went
off yesterday,
but it did not
go off today.
Perhaps you switched off the alarm function by
setting the control lever to the top position.
Perhaps you set a sound level and/or light intensity
level that is too low. Set a higher sound and/or light
intensity level.
Perhaps there was a power failure that lasted more
than approximately 15 minutes. In this case the
appliance has remembered all settings except the
clock time. The clock time therefore flashes on the
display. Set the correct clock time.
EnglisH 18