Panasonic AW-E860L - Manual (Page 27)

Caution:
• When horizontal phase adjustment is required using RCU
(RCB) or hybrid control panel, BAR/CAM switch should be
set to BAR. Horizontal phase cannot be adjusted if the
switch is in the CAM position. After adjustment set
BAR/CAM switch back to CAM.
• When horizontal phase adjustment is moved, colour phase
is also moved. Adjust colour phase whenever horizontal
phase adjustment is moved.
U
Colour phase adjustment
Supply the output signal (split colour bar) from the colour
special effect generator to a colour monitor or vectorscope.
Adjust the colour phase of the camera.
[ADJUSTMENT by camera]
1. Press the NO/BAR switch for over 5 seconds for the
colour bar mode.
2. Select [G/L Adjustment] on the main menu, then select
[SC Coarse] on the sub menu.
3. Make coarse adjustment with the YES/ABC switch and
the NO/BAR switch.
4. Select [SC Fine] on the sub menu. Perform fine
adjustment with the YES/ABC switch and the NO/BAR
switch.
[ADJUSTMENT with RCU (RCB, Hybrid control panel)]
Use the subcarrier phase coarse adjustment control and
subcarrier phase fine control.
❈ It is recommended that a vectorscope be used for
maximum accuracy in colour phase adjustment.
Caution:
• When colour phase adjustment is required using RCU
(RCB) or hybrid control panel, BAR/CAM switch should be
set to BAR. Colour phase cannot be adjusted if the switch
is in the CAM position. After adjustment set BAR/CAM
switch back to CAM.
• When horizontal phase adjustment is moved, colour phase
is also moved. Adjust colour phase whenever horizontal
phase adjustment is moved.
- 26 (E) -
ENGLISH
Colour bar of camera
Colour bar of special
effects generator
Sprit line