Panasonic AW-E860L - Manual (Page 50)

- 49 (E) -
Menu item setting
; Other Set Display
j Gamma Level Setting [Gamma: 0.35 to 0.55]
Gamma correction level can be set.
k Knee Level Setting
[Knee Point: 88% to 98%, Dynamic]
88% to 98%: The level of video signals subject to knee
(knee point) can be set.
Dynamic: Knee level is automatically adjusted
according to the scene.
l White Clip Level Setting [White Clip: 95% to 110%]
The peak level of video signals to be white-clipped can
be set.
m Flare Correction Level Setting [Flare R/G/B: 0 to 100]
Flare correction level can be adjusted.
n Black Stretch Setting [Black Stretch: ON, OFF]
Black stretch to correct the suppression of black portions
at low luminance can be set to ON or OFF.
o Clean DNR Setting [Clean DNR: OFF, Low, High]
This enables the clean DNR effect to be selected.
p CCD Read Out Mode Setting
[Field/Frame: Field, Frame 1, Frame 2]
Field:
CCD storage will be by field storage.
Frame 1: Vertical resolution increases in frame storage.
Frame 2: Vertical resolution is raised without increasing
residual images by frame storage and
electronic shutter.
q PC Control Access Speed Setting [Baud Rate:
1200bps, 2400bps, 4800bps, 9600bps]
This setting is to select a communication speed in
controlling the camera from the computer.
r Component Output Setting
[Signal Select: RGB, Y/Pr/Pb, Y/C]
This enables RGB, Y/Pr/Pb or Y/C to be selected as the
component signals which are to be output from the I/F
REMOTE connector.
s Aspect Ratio Selection [Aspect Ratio: 16:9, 4:3]
Aspect ratio can be selected from 16:9 or 4:3.
t Fan Setting [Fan SW: OFF, Auto]
OFF: Select this setting to stop the fan when its
operating sound is found to be bothersome in a
studio or other such environment.
Auto: The temperature is detected automatically, and
the fan starts operating when the temperature
exceeds approx. 35°C.
Under normal circumstances, the “Auto” setting is
used.