Panasonic SC-PT673 - Manual (Page 18)

18
RQ
TX02
10
Getting S
tarted
Playing
Discs
Ot
her Op
era
tions
Reference
Playing Discs Basic play
Preparation
To display the picture, turn on your TV and change its video input mode (e.g. VIDEO 1, AV 1, HDMI, etc.) to suit the connections to this unit.
[Note]
≥ DISC CONTINUES TO ROTATE WHILE MENUS ARE DISPLAYED.
To preserve the unit’s motor and your TV screen, press [ ∫] (Stop) when you are finished with the menus.
≥ Total title number may not be displayed properly on iR/iRW.
If you are experiencing problems, refer to troubleshooting ( B 32 to 33)
Using the main unit
Pull open
VOLUME
TUNE SELECTOR EXCHANGE 1 2 3 4 5
5 DISC SELECTOR
1 2 3 4 5
5 DISC SELECTOR
4
, + VOLUME EXCHANGE
1 2
SELECTOR
3
TUNE
(Stop)
POWER
MEMORY
5
OPEN CLOSE
Load the disc.
≥ Load double-sided discs so the
label for the side you want to play is
facing up.
≥ Press [EXCHANGE] to load discs
one by one.
≥ For DVD-RAM, remove the disc
from its cartridge before use.
≥ Do not:
– Load more than one disc per tray.
– Push or pull out the tray by hand.
Label
facing up
Start play.
≥ Turn [`, i VOLUME] to
adjust the volume.
Select “DVD/CD”. Turn on the unit.
Press to skip.
Press and hold to:
– search during play
– start slow-motion play during pause
≥ Press [1] (Play) to start normal play.
Open all the disc trays.
≥ To select a desired tray (B below, Selecting the desired tray).
≥ Press [<OPEN/CLOSE] again to close all the disc trays.
Press to select a disc directly.
≥ You can also select the disc using the remote
control ( B 19, Selecting a disc).
Selecting
the desired
tray
Press [ <OPEN/CLOSE] again to close the tray.
1 2 3 4 5
5 DISC SELECTOR
OPEN CLOSE
Change
discs
without
interrupting
playback
During play,
≥ All trays are opened (except the tray where the disc
is playing).
≥ Press [EXCHANGE] to close the top tray.
Press again until all the trays are closed.
≥ Press [<OPEN/CLOSE] to close all the open trays.
EXCHANGE
RQTX0210-1P_670-673_Eng.book Page 18 Friday, April 3, 2009 2:48 PM