Panasonic DMC-LS75 - Manual (Page 40)

40
VQT1C84
Advanced-Shooting
* 1 The fl ash is activated twice. The
subject should not move until the
second fl ash is activated.
■ Available fl ash settings by recording
mode
The available fl ash settings depend on the
recording mode.
( : Available, — : Not available, : Initial
setting)
* 2 It becomes Forced ON [ ], when the
backlight compensation function is
activated.
• The fl ash setting may change when you
change the recording mode. Change the
fl ash setting again if necessary.
• Flash settings are retained even if you
switch the camera off. However, scene
mode fl ash settings return to the factory
settings when you change the scene
mode.
■ The available fl ash range to take
pictures
ISO
sensitivity
(P60)
Available fl ash range
AUTO 30 cm to 4.7 m (Wide)
30 cm to 2.6 m (Tele)
ISO100 30 cm to 1.8 m (Wide)
30 cm to 1.0 m (Tele)
ISO200 40 cm to 2.6 m (Wide)
30 cm to 1.4 m (Tele)
ISO400 60 cm to 3.7 m (Wide)
40 cm to 2.1 m (Tele)
ISO800 80 cm to 5.3 m (Wide)
60 cm to 2.9 m (Tele)
ISO1250 100 cm to 5.3 m (Wide)
80 cm to 2.9 m (Tele)
• Refer to P106 for the focus range.
• When you use the fl ash when you have
set ISO sensitivity to [AUTO] or set
ISO LIMIT in Intelligent ISO mode [
]
to anything other than [ISO400], ISO
sensitivity automatically becomes a
maximum of [ISO640] ([ISO400] in the
[BABY1]/[BABY2] or [PET] scene modes
(P46)).
• The edges of the picture may appear
dark if you shoot a very close subject with
the fl ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
* * 2 2