Pentax OptioWP - Manual (Page 26)

24
1
Gettin
g
Sta
rte
d
• Image Storage Capacity and Playback Time
(at 23°C with the LCD monitor on, the flash used for 50% of shots and the
battery fully charged)
• The still picture storage capacity is based on measuring conditions in
accordance with CIPA standards. The playback time is based on
PENTAX measuring conditions. Some deviation from the above figures
may occur in actual use depending on shooting mode and shooting
conditions.
• Battery Level Indicator
You can check the battery level by the w indicator on the LCD monitor.
• This camera uses a rechargeable lithium-ion battery D-LI8. Use of
any other type of battery may damage the camera and cause
malfunction.
• Insert the battery correctly. If the battery is incorrectly oriented,
malfunction may result.
• Do not remove the battery while the camera is turned on.
• If you do not intend to use the camera for a long time, remove the
battery.
• The date and time may be returned to the default setting if the
camera is left without the battery for a long time.
• Allow the camera to dry completely before changing the battery.
Avoid changing the battery where the camera is likely to get wet or
dirty, and make sure that your hands are dry.
Image Storage Capacity Playback Time
Approx. 180 pictures Approx. 230 min.
• In general, battery performance may temporarily deteriorate as
the temperature decreases.
• Be sure to take a spare battery with you when traveling abroad or
to a cold region, or if you intend to take a lot of pictures.
Screen Display Battery Status
w (green) Adequate power remains.
x (green) Battery is running low.
y (yellow) Battery is running very low.
z
(red) Battery is exhausted.
[Battery depleted] The camera will turn off after this message appears.