Peavey PR 10P User Manual
Page 6
6
((4
4)) P
PO
OW
WE
ER
R//C
CLLIIP
P LLE
ED
D
Illuminates GREEN when the electronics receive power (when the Power switch (3) is On). Illuminates RED
when amplifier clipping is occurring or the unit has tripped the thermal protection system.
((5
5)) P
PR
RIIM
MA
AR
RY
Y IIN
NP
PU
UT
T ((C
CH
HA
AN
NN
NE
ELL 11))
The primary input is switchable between line-level and mic-level input. The line-level input is of the
medium impedance balanced type, and when switched to mic-level it is of a typical low-Z mic input
impedance. Jack (5) is a combo female XLR and 1/4" TRS connector.
((6
6)) P
PA
AD
D
Switches the sensitivity of Channel 1 from line-level to mic-level sensitivity. Pushed all the way in, the
sensitivity is set for line-level input signals, and when the white tab is closer to the front panel, the
sensitivity is increased by 30 dB so it is suitable for mic-level signals.
((7
7)) V
VO
OLLU
UM
ME
E
Controls the gain (level) of the Primary Input (5), Channel 1, of the powered speaker system. It is used to
directly set the system output level for the Channel 1 input signal.
((8
8)) S
SE
EC
CO
ON
ND
DA
AR
RY
Y IIN
NP
PU
UT
TS
S,, C
CH
HA
AN
NN
NE
ELL 2
2 &
& 3
3
These consist of 1/4" unbalanced phone jacks for line-level signals, with medium input impedance.
((9
9)) C
CO
ON
NC
CE
EN
NT
TR
RIIC
C V
VO
OLLU
UM
ME
E,, C
CH
HA
AN
NN
NE
ELL 2
2 &
& 3
3
Controls the gain (level) of Channel 2 & 3 inputs. Can be used in conjunction with the Channel 1 volume
control (7) to mix three line-level signals together, or two line-level signals and one mic-level signal.
4
9
8
6
7
5
FF R
R O
O N
N T
T P
P A
A N
N E
E LL