Pentair EasyTouch 8 and 4 Pool and Spa Control System - Manual (Page 8)

2
EasyTouch Load Center Installation Guide
EasyTouch Accessory Equipment (continued)
EasyTouch Indoor Control Panel, 4 Circuits (P/N 520548)
EasyTouch Indoor Control Panel, 8 Circuits (P/N 520549)
EasyTouch Wireless Control Panel, 4 circuits (P/N 520546)
EasyTouch Wireless Control Panel, 8 circuits (P/N 520547)
iS4 Four-Function Spa-Side remote, 150 ft. cable (P/N 520094)
Two-Speed Three HP Relay up to three additional valve actuators (P/N 520198)
Three HP Power Relay (P/N 520106)
QuickTouch four-function wireless remote kit with transceiver assembly (P/N 520148)
IntelliChlor Acid Cleaning Kit (P/N 520670)
IntelliChlor Spacer pass-through cell for new pool start-up (P/N 520588)
EasyTouch System Installation Steps Summary
The recommended EasyTouch system installation steps are:
Prepare and install EasyTouch load center (pages 6-9): Review high voltage Load center
connections (see page 6). Prepare and install the EasyTouch load center at the equipment pad.
AC power for the EasyTouch load center must be provided from the main-panel located at the
house.
Remove EasyTouch load center knockouts/install conduit and wire to EasyTouch load
center (pages 10-11).
Install Auxiliary Relays and Valve Actuators (pages 15-16): Install auxiliary relays and the
valve actuators on the valve assembly and connect cables to the EasyTouch motherboard.
Install Temperature Sensors and Heat Thermostat (pages 17-18): Install the water and air
sensors and connect the cable plugs to the EasyTouch motherboard.
Connecting IntelliChlor cell (page 19): Connect the IntelliChlor cell to the EasyTouch load
Center. This optional equipment is include with IntelliChlor salt chlorine generator system only.
EasyTouch System Start-up (page 19): Perform a system start-up procedure.
Required Tools
• 5/16 in. diameter drill (for mounting water temperature sensor).
1
2
3
4
5
6