Patton electronic COPPERLINK 2160 - Manual (Page 20)

Model 2160 rear panel 20
Model 2160 Series User Manual 1 • General information
Model 2160 rear panel
Port descriptions
The CopperLink™ Model 2160 rear panel ports are shown in figure 3 and described in table 3 .
Figure 3. Model 2160 rear panel
Note For port pinout information, see Appendix C, “Port pin-outs” on
page 111.
Table 3. Port descriptions
Port Description
Power Power adaptor inlet: Input voltage 9VDC
Console (RS-232 control port) Used for service and maintenance, the Console port, an RS-232
RJ-45 connector with EIA-561 pinout, connects the router to a
serial terminal such as a PC or ASCII terminal (also called a dumb
terminal). Asynchronous default data rate 9600 bps, hardware
DSR and DTR signals for external modems are wired directly
together internally
Reset Reset button for rebooting or loading factory default settings
LAN (LAN Ethernet Ports 1-4) 10/100Base-Tx full-/half-duplex, RJ-45, auto detection and fall-
back, connects the unit to an Ethernet LAN.
Management RJ-45 for management port
Line Interface for WAN port (RJ-45)
Power
Console
RS-232 port
Reset button
LAN (1-4)
RJ-45 port
Management
RJ-45 port
Line
RJ-45 port
Ground
+ -
Power Console
Reset
Management Line
LAN
1 2 3 4 9V, 1A
+
-
Power
Console
Reset
Management
Line
LAN
1
2
3
4
9V, 1A