Pentair IC20 - Manual (Page 6)

iv
IntelliChlor Electronic Chlorine Generator Installation and User’s Guide
IMPORTANT SAFETY PRECAUTIONS
CAUTION - Use of chemicals other than those recommended may be hazardous. Even proper use of the
recommended chemicals can be hazardous. Follow the Chemical Manufacturer’s Instructions.
CAUTION - To reduce the risk of electric shock, install IntelliChlor Electronic Chlorine Generator (IECG)
a minimum of five (5) feet away from the inside wall of the pool.
CAUTION - Install the IECG a minimum of three (3) feet away from the heater outlet.
CAUTION - It is recommended to install a Pentair two (2) inch CHECK VALVE (P/N 263042) between
the input side of the IECG and the main heater output pipe.
CAUTION - A solid copper, bonding conductor not smaller than No. 8 AWG (8.4 mm) should be connected
from the accessible wire connector on the unit to all metal parts of the swimming pool, spa, or hot tub structure
and to all electrical equipment, metal conduit, and metal piping within five (5) feet (1.5 m) of the inside walls of a
swimming pool, spa, or hot tub, when the unit is installed within five (5) feet of the inside walls of the swimming
pool, spa, or hot tub.
Canada - Industry Canada (IC) - This device complies with RSS210 of Industry Canada. (1999)
FCC Standard - 47 CFR Part 15, Subpart C (Section 15.247). This version is limited to chapter 1 to chapter 11
by specified firmware controlled in the U.S.A.
Federal Communications Commission (FCC) - This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Interference Statement - This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Modifications not expressly approved by the party responsible for FCC compliance could void the user’s
authority to operate the device.
SAVE THESE INSTRUCTIONS
W ARNING: When mixing acid with water, ALWAYS ADD ACID TO WATER. NEVER ADD
WATER TO ACID.