Pioneer PDR-509 - Manual (Page 31)

31
Additional Features
Additional Recording Features
FINALIZE
ERASE
TIME
FADER
DIGITAL
SYNCHRO
INPUT
SELECTOR
SKIP
PLAY SET
SKIP ID
CLEAR
AUTO/
MANUAL
TRACK NO.
WRITE
REC
1 2 3 4
7 8 3
1 ¡ 4 ¢
Î
2
1
Checking What's at the End of a Disc
You don't have to record a whole disc at once. Until you finalize the disc, further recording is possible from the end of the
last track you recorded (assuming there are fewer than 99 tracks already on the disc). Here's how to check what's on the
last recorded section of the disc before recording new material:
1
Press
¶ RECORD.
The recorder goes into record-pause mode.
2
Press and hold
1 (fast-reverse).
You'll hear the last recorded track in reverse. Release the button and the
track plays normally to the end.
❖ While the track is playing you can use the 1 and ¡ (fast-reverse/
forward) buttons
❖ If you press ¶
RECORD again while the track's playing, the recorder
jumps to the end of the track and goes into record-pause mode again.
When the track has played out, the recorder automatically enters record-
pause mode again.
3
Once the player is back in record-pause mode you
can go ahead and record normally.
If you decide you don’t want to record, just press 7 (stop).
Recording Blank Sections
This feature is useful when you want to put some space at the end of a recording session so that the next recording doesn't
start after the last too closely, but use it wherever you need some blank space recorded on the disc.
There are a couple of
restrictions on using record mute: you can only record one mute per track; and you can’t begin a recording with a muted
section — you can use it only after the recording has started, or at the end of a recording.
1
While recording or during record-pause mode,
press
• REC MUTE.
A blank space of about four seconds is recorded, then the recorder goes
into record-pause mode.
❖ If you press and hold
•
REC MUTE , you can record a blank for as long
as you hold down the button.
❖ Pressing •
REC MUTE , (without holding) in record-pause mode records
four seconds of silence from the current position. Use this to create a
space between tracks when recording in 1-track synchro mode, for
example.
2
Press
7 (stop) to finish the recording session.
❖ To restart recording, press either 3 (play) or 8 (pause).
DIGITAL
REC LEVEL
ANALOG
REC LEVEL
REPEAT
1 2
DIGITAL
REC LEVEL
ANALOG
REC LEVEL
REPEAT
1 2
FINALIZE
ERASE
TIME
FADER
DIGITAL
SYNCHRO
INPUT
SELECTOR
SKIP
PLAY SET
SKIP ID
CLEAR
AUTO/
MANUAL
TRACK NO.
WRITE
REC
1 2 3 4
7 8 3
1 ¡ 4 ¢
О
1
2