Monitoring a source, Checking for digital copy protection, Additional recording features – Pioneer PDR-509 User Manual

Page 32: Start the source component playing, Press monitor, Start playing the digital source

Advertising
background image

32

Additional Recording Features

◊ÛB-.?/

MONITOR

INPUT

SELECTOR

TIME

Monitoring a Source

If you have a set up like the figure below or like that on page 11, you can monitor the source without changing the input
function of the amplifier from the PDR–509 (you could also monitor through a pair of headphones connected to the
PDR–509's phones jack).

When recording, or in record-pause mode, the source signal is always available for monitoring from the analog outs of the
PDR–509. Even if you're not recording, you can still monitor—useful for cueing up a disc or tape for the next recording.

1

Start the source component playing.

Make sure that the input selector is set to the correct input.

2

Press MONITOR.

If the source is digital, the display indicates the input (

CD

,

MD

,

DCC

,

DAT

,

DVD

,or – – – – if the source is unknown). then the sampling rate (

32

K

,

44

K

or

48

K

). If the source is copy protected, the message

CAN

NOT

COPY

appears (see below for more on this), otherwise the display shows

MONI

(monitoring). If the source is analog, the display just shows

MONI

.

The source signal is fed through the analog outs of the unit, allowing you
to monitor.

3

To switch off monitoring, press MONITOR again.

◊ÛB-.?/

MONITOR

INPUT

SELECTOR

TIME

2,3

Source (CD, etc)

PDR–509

Amp (input set to

PDR–509)

Digital

or Analog

connection

Analog

connection

Checking for Digital Copy Protection

Using the

MONITOR

button, you can also check whether or not a digital source is copy-protected with

SCMS

(Serial Copy

Management System).

SCMS

allows you to make digital copies of original sources for your own use, but prevents further

digital copies being made from the copy.

1

Start playing the digital source.

Make sure that the input selector is set to the correct digital input.

2

Press MONITOR.

The display indicates the input source (

CD

,

MD

, etc.) and its sampling

rate, follwed by

CAN

NOT

COPY

if the source is digital-copy protected.

If the display shows

MONI

(monitor), you can go ahead and record

normally.

Original source

(CD, MD*, etc.)

Digital

copy

Digital

copy

Analog

copy

CD–R/

CD-RW

CD–R/

CD-RW

*Not a digitally
copied MD!

2

Advertising