Precor LOW-IMPACT TREADMILLS 9.33 - Manual (Page 53)

Owner’s Manual: Advanced Programming and Troubleshooting 51
Selecting a U.S. Standard or Metric Display
The treadmill can display measurements in either Metric or
U.S. Standard. The default factory setting is set to display
U.S. Standard. To change this setting, perform the following
steps:
4. At the SELECT UNITS prompt, press OK. Use the
navigational arrow keys to select a unit of measure (U.S.
or METRIC).
5. When you are ready, press OK to accept the display
setting and move to the next program. Or, press PAUSE/
RESET to return to the banner.
Setting a Pause Time Limit
You can limit how long a user can pause while exercising on
the unit by entering a time between 1 and 10 minutes. For
example, if you set the pause time limit to 1 M, the display
automatically resets to the banner if no key press occurs
within one minute.
6. At the SET MAX PAUSE TIME prompt, press OK. Use
the navigational arrow keys to change the time limit.
Choose between 1 and 10 minutes.
7. When you are ready, press OK to accept the displayed
setting and move to the next program. Or, press PAUSE/
RESET to return to the banner.
M9.33-931_Owners Manual.book Page 51 Friday, January 11, 2008 7:42 AM