Philips HP1500 - Manual (Page 16)

When connecting your audio equipment in this way, you will be able to benefit
from the Automatic Audio Signal Routing (AASR) feature. As long as the base
station is powered – even in stand-by mode – the audio signal from the audio
source will be made available not only to the digital base station but it will be
routed through to the rest of your home entertainment set-up. Without the need
for swapping cables you can decide whether you wish to enjoy the audio
through your headphones or through for example the speakers of your home
entertainment system.
3 Check if the red RCA plug (right channel) is connected to the right
channel (red) of the audio source.
The white RCA plug (left channel) must be connected to the white
connector (left channel) of the audio source.
4 Power on your audio source: switch on your audio source, i.e. stereo TV,
stereo VCR, (S)VCD player, tape recorder, etc.
5 Output adjustment of your audio source: in case the line output of your
audio source has an adjustable output level, adjust the line output level of
the audio source to the highest acceptable undistorted level.
Note: In case of certain TVs, the line output level can only be
adjusted through the TV’s on screen menu.
6 Power on the base station: switch on the digital base station.
The power indication LED of the base station will change from red to
green.
7 Sensitivity switch: if your audio source’s output signal is relatively weak,
the sensitivity switch at the back of the digital base station should be
changed from 0dB to +6dB.This will provide the necessary additional
amplification to the audio input signal prior to processing.
If this results in a distorted signal, then set the switch back to 0dB.
8 Source select: select the analogue input on the base station by pressing
the ‘Source’ button.
9 Input signal detection: once a stereo audio signal is detected the input
signal indicator ’STEREO’ will be illuminated.
Note: In case of multilingual NICAM transmissions, you should select
the appropriate language in your TV’s menu. In that case the
audio signal will no longer be stereo but only mono and the
effect of for example Dolby Pro Logic II or Dolby Headphone
will very be limited.
ENGLISH 16
0912HP_EU 09-12-2003 12:12 Pagina 16