Pantech PG-3500 - Manual (Page 66)

128
Receive Mode [1.6.2]
Sets up Push Message receiving.
- Accept All: Receives all Push messages.
- Accept None: Rejects all Push messages.
Go to URL [1.7]
Allows you to directly input and connect to the desired URL.
Profiles [1.8]
Selects or edits the Connection Profile supplied by the
phone.
Select the Profile List and press the [
o
] key for setup.
The Unedited Profile will not be selected.
Select the Profile List and press the [Edit] Soft key to edit a
profile.
- Profile Name: Pressing the [
o
] key allows you to enter the edit
mode to change a profile name.
- Home URL: Pressing the [
o
] key allows you to enter the edit
mode to edit the Homepage URL provided by the service
provider.
- Connection Type: Select either WAP or HTTP.
- GSM Settings: This menu allows you to set the GSM network
proxy, and has the following sub-menus:
- Gateway/Proxy: If you set the Connection Type for WAP,
Gateway appears. If you set it for HTTP, Proxy appears.
Pressing the [
o
] key allows you to access the sub-menus such
as IP Address, IP Port, Login ID and Password. For each sub-
menu, pressing the [
o
] button lets you enter edit mode to edit
every item provided by the service provider.
- Data Call Type: Use the left or right navigation key to select
from the two modes: ISDN and Analogue.
- Dial Number: Pressing the [
o
] key allows you to enter the edit
mode to change this item.
- Login ID: Pressing the [
o
] key allows you to enter the edit
mode to change this item.
- Password: Pressing the [
o
] key allows you to enter the edit
mode to change this item.
- GPRS Settings: This menu allows you to set the GPRS network
proxy, and it has the following sub-menus:
- Gateway/Proxy: If you set the Connection Type for WAP,
Gateway appears. If you set it for HTTP, Proxy appears.
Pressing the [
o
] key allows you to access the sub-menus such
as IP Address, IP Port, Login ID and Password. For each sub-
menu, pressing the [
o
] key lets you enter edit mode to edit
every item provided by the service provider.
- APN: It stands for Access Point Name. Pressing the [
o
] key
lets you enter the edit mode to change this item.
- Login ID: Pressing the [
o
] key lets you enter the edit mode to
change this item.
- Password: Pressing the [
o
] key lets you enter edit mode to
change this item.
- DNS Settings: Enter the IP address for the Domain Name Server.
You may enter primary and secondary DNS. This function is
available only when you are connected to HTTP.
- Bearer: This lets you select the bearer type for each type of
network access. Using the left or right navigation key allows you
to select from the two modes: GSM Only and GPRS Only.
- Reset Profile: Pressing the [
o
] key initializes the parameter
settings of a profile. You can select from Yes/No.
129
WAP WAP
NOTE: The parameter settings are already entered as required by the
service provider. Care should be taken when you make any modification
to a profile since it may cause WAP to be inoperative.