Precor EFX 5.21i - Manual (Page 37)

Owner’s Manual: Advanced Programming and Troubleshooting 35
Informational Displays
The EFX provides information about its use (odometer and
hour meter), as well as software version and error log. In
general, you would only access this information if directed to
do so by Precor Customer Support.
These instructions guide you through all four informational
displays. Pressing the SELECT key moves you through the
displays. To exit, press the RESET key at any time.
Viewing the Odometer
1. At the Precor banner, press the following keys in
sequence and without pause:
RESET, RESISTANCE ▼, SELECT
Numbers 6, 5 appear on the display as you press the
associated key.
STRIDES: scrolls across the display followed by the
odometer value (the cumulative strides users have taken).
The information continues to scroll across the display.
2. When you are ready, press SELECT to move to the next
display (hour meter).
Displaying the Hour Meter
HOURS: appears followed by the number of hours that
the unit has been in use. The EFX tracks the elapsed
minutes, but the value that appears is truncated to the
nearest full hour.
3. When you are ready, press SELECT to move to the next
display (software version).
Viewing the Software Version and Part Numbers
UPPER SW: appears and then the unit’s upper board
software part number and version (for example, V47475-
205) scrolls across the display. The lower board’s
software version number follows it. After the upper and
lower board software versions, UPPER BOOT: appears,
and provides the upper boot part number.
4. Write these numbers in the space below. You will need
these numbers when you call Customer Support with
display-related questions. This information will help rule
out any software-related problems.
Upper Board P/N: ________________________
Lower Board P/N: ________________________
Upper Boot Number: ______________________
5. When you are ready, press SELECT to move to the next
display (error log).