Plantronics CS70 - Manual (Page 9)

 Questions?
For fast, efficient Technical Support call:
800-544-4660 Ext. 5538
Peel back
mounting tape
protective strips
(3 places)
6
. Check the Lifter height adjustment by moving the Lifter Height Switch to a higher position.
Repeat steps 2. through 4. as necessary.
If you hear a dial tone, the lifter height is now set correctly. Please continue with the next
section “Mount the Lifter in Permanent Position”.
7
. If you still cannot hear a dial tone,
you will need to change the setting
on the Configuration Dial.
Using a coin or paperclip,
turn the Configuration Dial to
a different setting until you hear a
dial tone. Multiple settings might work
with your phone; however, only one is the
optimal position. If you still cannot hear a dial
tone, please call Technical Support
at 800-544-4660 Extension 5538.
To view an interactive set-up guide online, visit www.plantronics.com/cs70setup
and click on Compatibility.
1
. Remove the protective strips from the three mounting tapes on the underside of the Lifter.
2
.
gently
place the Lifter on the desk phone in the optimum position as determined above.
Test the Lifter to verify positioning by pressing the Call Control Button on your headset to
activate the Lifter and listen for a dial tone.
3
. Press firmly to adhere the Lifter to the desk phone.
C. Mount the Lifter in permanent position
Configuration
Dial
Position Indicator
If your handset falls off the phone base or
does not return to its cradle when lowered,
you will need to attach the Extender Arm to
the Lifter as described in the HL10 Additional
Parts Kit.
Use the Extender Arm to Stabilize
Handset (if needed)